One of the hazards of building a bridge in the woods is that there are trees in the woods. And trees sometimes fall. It was only a couple of weeks after my bridge was completed that a tree fell on it. It bounced off without causing damage other than a dent in a deck board.
A couple of years ago during a flood, a tree next to the bridge came down, and while not actually falling on the bridge, parts leaned heavily on the suspension cable. I cut off the branches that were in our way and let the rest stay for now since I was busy with other projects. This spring I finally cut the rest of the tree that was affecting the bridge cable. I knew that the deck had sagged a bit and would need to be adjusted at some point.
That’s why I have turnbuckles installed on all the deadman-to-post cable connections as shown in my book, Building a Small Cable Suspension Bridge. I could just turn them to pull the posts back and level out the deck again.
I used what was handy to provide a resistance (something to work against) to turning the turnbuckle – in this case a big stick and a metal pipe.
WD40 oil worked to loosen up the connections. They weren’t rusty having been protected under the cover of those white tubes all these years, but they didn’t want to break loose easily.
I used a small bar for turning, but a longer one could have made things easier.
I used a pencil mark to verify if I was tightening or loosening.
Once they broke loose, each turnbuckle turned easily.
Jeep seemed amused that one side was now lower than the other. But that’s just part of the process!
I worked on all four turnbuckles, using line of sight to achieve the results I wanted.
All done, until the next tree takes a dive into the creek and the bridge is in its way.
This all only took about 30 minutes. Here’s a movie of the process if you’ve never seen a turnbuckle in action.
Thanks for stopping by! Be sure to check out our suspension bridge book. Here is the link:
Images, diagrams, and text copyright 2013-2017 by Marvin Denmark unless otherwise noted. Please do not copy and post my content anywhere without my permission. Thank you.