After a long, wet winter, we finally got a few sunny days to assemble the ring to the tower and then lift it up! To note, this is a ring for a 6′ dome and we’ll be talking about a 3′ dome in the book. It’s a lot easier to build and manage. This 6′ ring weighed about 200 pounds. As you can see, there’s a 12g metal ring inside (for added strength) that adds to the weight.
The ring will be temporarily held in place by a tower. Once the rafters are bolted into place, the tower goes away. When I assembled yurts in the past, the tower wood would be salvaged and used for interior wall framing.
Once the components were ready and it was dry enough to drive to the yurt, it was time for installation. The tower was built so I could just take out a couple of screws and then finish assembly on-site. The ring required a neighbor with a strong back to muscle it into its new home.
You can see the tower parts on the right side of the yurt. I assembled the tower on the inside, given that it would not fit through the door otherwise.
The next step was to attach the tower to the ring…
and strap it in readiness for hoisting. To keep the bottom from sliding out I attached a cable that laced through the outside legs and bolted to two walls on either side.
After shoving it against the far wall, I jacked it up about 2-1/2′ to make the angle of the strap going over the doorway and to the truck a little less severe. I installed a cut pipe on the doorway so the strap would slide easily. You can see the cable attached to the wall in this photo.
I put small lengths of conduit underneath the tower so that I could shove it into place after determining the center.
The last step was to turn it so it is lined up to the 12 rafter corners on the walls. Check out the homemade plumb bobs (plummets).
We’re ready for the rafters! Stay tuned while we once again wait for it to stop raining.
We are writing a detailed book about the entire process from start to finish so we can share how to build this yurt with anyone who is interested! Be sure to check back as we progress, and be on the watch for news on the book. You can also find us on Facebook.
Thanks for stopping by! Photos by Robin Koontz and Marvin Denmark.